Suspension setup, calculated
Dial in your fork before the first run.
Tell us your weight, your bike and the fork you ride. MTBsetup works out the air pressure and volume spacers that match how hard you ride, from the physics of your fork's air chambers.
- fork configurations measured in the lab
- 53
fork configurations measured in the lab
- air chambers modelled, not just one
- 4
air chambers modelled, not just one
- rider levels, from first laps to World Cup
- 6
rider levels, from first laps to World Cup
- to calculate a complete setup
- <10 ms
to calculate a complete setup
Not a chart on a sticker. A model of your fork.
Pressure charts on the fork leg only know your weight. MTBsetup also knows how your fork is built, how you sit on the bike and how much of the travel you should use.
Your data
Weight with gear, riding level, riding position, bike weight and head angle. The head angle changes how much of your weight goes into the fork.
Air spring physics
Positive and negative chambers, plus the air trapped in the lower legs. Each one follows the gas laws, measured on every fork in our lab.
Fine-tune live
Change pressure or spacers and watch the spring curve, SAG and bottom-out resistance move in real time, before you touch the pump.
For bike shops
Hand over every bike already set up.
Calculate a setup for each customer in under a minute, save it, and get back to it at the next service.
- NextSetup for every customerFork and shock calculator with hydraulic recommendations.
- NextSetup historyEvery setup saved per rider and per bike, ready to compare.
- NextFind a local serviceRiders find shops that offer suspension setup and service.